![]() ![]() You will now see the inside of your door. Now, pry all around the edges, and pull the panel straight up and pull than set it on the ground. Pull slowly and make sure screw-driver is directly next to plastic screw. ![]() Now take a bigger flat head screw-driver and pry around the edge of the panel where there are little plastic retaining screws. Remove screws by mirror, and around the door armrest, use a flathead screwdriver to pop out the electric window/door lock controls and unplug the wire harness. SOURCE: Drivers door window is off it's carrier Rail ![]() if necessary add more sealant to hold it in place. it install the trim panel first press the watershield back into place. SOURCE: 1991 Nissan Maxima: Removal of front driver side door panelĢ on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.ģ on power window equipped models pry out the armrest switch control plate and disconnect the electrical connectionsĤ detach the armrest pull handle retaining screw then remove the inside door handle trim bezelĥ insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.Ħ once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.ħ for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |